I'm looking for someone to design a PCB for me. I need it for a little business I'm working on. I have wanted to do it myself, but...
Aurelio FTW! Soo... anyone know of a reasonably priced 3.5 inch vga screen?? ;)
If you will also be using duct tape, I'm all for it.
I finished the final print of my case today. I made a few modifications, including screw posts. It came out really nice, although I will still...
Thanks! And yeah that's what I've been doing with test prints so far. I've been considering making them detachable, but I'm not sure yet.
I think it would still end up being half the Wh of the piiwii. I could be wrong though. Haha
It's smaller, but only has 2 cells instead of 4, which is a pretty big compromise. Haha but with powermii charge and play it won't be too bad. :)
Nah. I considered those, but they were just slightly too small for my liking. plus I would have to trim them down. So I decided to print them. I...
Here's a pic to help visualize how small it is
I've started working on another portable recently so I thought I'd make a worklog! I really wanted my next portable to comfortably fit...
This might be my new favorite portable. I seriously love everything about it. Great job!
Old pc power supplies are great if you want the set voltages that you mentioned. If you want variable, LTC3780 modules are good. I'm sure there...
Yeah they are just the soft rubber tact switches from the BOM.
Your case is money. It's so clean. I've been learning fusion 360 as well and making my case in it. I've REALLY loved it!!
A 3d printer may also have trouble printing those tiny speaker grill holes. I remember ginger had a problem with this in his. I love your case...
I'm sure Nintendo would have made it smaller if they could have at a reasonable cost. Sooo..
Are you using the pads on the top of the module or the tiny pins on the connector on the bottom of the module?
Either way, the other one will be...
Separate names with a comma.