Recent Activity

Activity stream for all registered members at BitBuilt - Giving Life to Old Consoles.

  1. Matando liked Fruity_Grebbles's post in the thread Worklog World's Smallest Gamecube.

    Hey you made Hackaday!

    Apr 20, 2019 at 3:21 AM
  2. Fruity_Grebbles replied to the thread Worklog World's Smallest Gamecube.

    Hey you made Hackaday!

    Apr 20, 2019 at 3:15 AM
  3. BocuD liked The Next Guy's post in the thread Discussion Share your tattoo/s.

    [ATTACH]

    IMG_20190417_171114.jpg Apr 19, 2019 at 9:36 PM
  4. Stephano liked GingerOfOz's post in the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Might be a bit overkill, but should be ok. Be sure to remove any components outside of the trim line if you do trim a bit wife though.

    Apr 19, 2019 at 7:20 PM
  5. GingerOfOz replied to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Might be a bit overkill, but should be ok. Be sure to remove any components outside of the trim line if you do trim a bit wife though.

    Apr 19, 2019 at 7:17 PM
  6. Stephano attached a file to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    [ATTACH][ATTACH] So.... Do you think this is good. I'm sorry, I'm just super nervous and have to make sure. The tape goes out a little...

    upload_2019-4-19_13-13-43.png upload_2019-4-19_13-14-10.png Apr 19, 2019 at 7:15 PM
  7. The_Smeags posted a new thread.

    Snes jr (model2)

    [ATTACH] I bought one of these bad boys at a pawn shop It came with two original controllers, no cords or games It does work though. I...

    IMG_3158.JPG

    Forum: Selling

    Apr 19, 2019 at 7:07 PM
  8. Nold replied to the thread Raspberry Pi Zero v1.3 full scans.

    google drive link is down.. please attach it to the thread. thx! @lyberty5

    Apr 19, 2019 at 7:04 PM
  9. GingerOfOz replied to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Don't worry about stuff being slightly different too much. That C17 is a cap for the 1.15v line and it's normal for it to move around...

    Apr 19, 2019 at 6:54 PM
  10. Stephano liked GingerOfOz's post in the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Sounds like you're ready to cut! Just make sure to put masking tape over the CPU/GPU/RAM to keep dust from getting underneath there and...

    Apr 19, 2019 at 6:51 PM
  11. Stephano attached a file to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    (Sorry for the double post) I understand not as much research as been done on the 6-layer board as the 4-layer board, but since my...

    upload_2019-4-19_12-44-11.png Apr 19, 2019 at 6:44 PM
  12. Stephano replied to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    I guess I can always resolder the points. I mainly did all of this relocation before hand just to make sure that once it is cut, It will...

    Apr 19, 2019 at 6:35 PM
  13. GingerOfOz replied to the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Sounds like you're ready to cut! Just make sure to put masking tape over the CPU/GPU/RAM to keep dust from getting underneath there and...

    Apr 19, 2019 at 6:31 PM
  14. Stephano liked GingerOfOz's post in the thread Question First Wii Portable (Gwii Case). Several Questions before I start trimming..

    Try making you data wires shorter. It's best for then to not be longer than they have to be. Also I assume that drive works just fine...

    Apr 19, 2019 at 6:29 PM
Loading...