Worklog Unnamed N64p

Joined
Dec 8, 2016
Messages
34
Likes
33
Screen has arrived finally, not sure which way the ribbon cable goes. Came with no diagram or anything.
screen.jpg
 

fibbef

Wizardry V Completer
.
Joined
Nov 10, 2016
Messages
606
Likes
1,625
Best guess would be the way you have them laid out. My reasoning is that when connected, the driver board sits fully behind the screen. If you tried flipping it, the driver board would stick out past the left side of the screen.
screen.jpg

Pardon the crap quick paint job.

But don't go making assumptions and breaking stuff. Peek inside the connector and see where the pins lay.
 
Joined
Dec 8, 2016
Messages
34
Likes
33
I think there are pins on both side, but theres only a 1 sided connector, perhaps there's another version with a higher resolution?
 
Joined
Dec 28, 2016
Messages
107
Likes
833
On that driver board, pin 1 will be on the left side. There should be a tiny circle on the FFC connector.

On the display FFC there will also be a small arrow on the left side. That means they plug in flat (display facing up)
 
Joined
Dec 8, 2016
Messages
34
Likes
33
Yeah, that worked, video is a bit smudgy, but what can you expect with composite lol.
 
Top