- Joined
- Jun 26, 2021
- Messages
- 35
- Likes
- 24
So before I waste anyones time by writing a whole speech for someone to ask, I'm using(attempting to use I think is the right word here?) Mp1584 EN module boards for my power supply. Anyone had luck with these?
On my third motherboard(starting to run out of wiis with dre's to buy locally, haha), all I did u10 relocation first to confirm it worked, then cut with diamond cut off wheel, and sanded with 80, 200 & 600 grit sanding blocks to chamfer the edges to avoid shorts. They all tested within expected ranges when I tested resistance, but all 3 do the exact thing, quick blip on the screen then all the voltages jump up by .08-0.3 volts and then it just sits there doing nothing. Thanks in advance!
On my third motherboard(starting to run out of wiis with dre's to buy locally, haha), all I did u10 relocation first to confirm it worked, then cut with diamond cut off wheel, and sanded with 80, 200 & 600 grit sanding blocks to chamfer the edges to avoid shorts. They all tested within expected ranges when I tested resistance, but all 3 do the exact thing, quick blip on the screen then all the voltages jump up by .08-0.3 volts and then it just sits there doing nothing. Thanks in advance!