Gman, you're amazing and we all now in awe of your genius. But please... Photobucket...
Why...
I only do it to inconvenience you guys.
Ok this is pretty much as far as you would want to cut without being insane or making irregular cuts. Cutting any further will require relocating the ethernet IC which as far as I am aware, it is still required for boot. Also any further and the voltage relocations will probably get tricky.
So here are the boot requirements for this trim:
-4 custom regulators. 5v is not a boot requirement and is no longer present on the board. I am only using it for the logic level shifter and usb. The screens that I have tested will still be triggered without the logic shifter anyway.
-3 voltage lines reconnected
-2 pullup resistors relocated
-1 trace reconnected for the ethernet ic
-Reset tact
Of course you won't be able to see anything and will require to solder 24bit RGB, h/v sync, and video clock for a video dac if that is the route you want to go. After all this work, the board is about the same size as an OMGWTF wii.