Notice: I would not use this for the N64HH build, that specific driver board will be released separate from this.
This is the release of my Custom PCB that allows you to use simple Button Combinations to control the display and volume of your portable!
Pinout:
S1- Selector Button 1 (Volume...
This is the start of my worklog for my Wii portable! I found an old design I made 3 years ago in my closet, so I remade it and am working hard to finish it!
It is based of JacksonS's Wii SP 2.0 a while back. I have gotten a lot better at making custom PCBS, so I hope to keep it clean and easy...
I used the FPC for power button, audio, Z and R buttons, controller board data, a couple for ground and for 3.3v
I twisted two magnet wires, one ground, one video out, for the video. Running video through the FPC gave me interference on the display.
Hey guys I have 4 batches of JLCPCB ENIG gold plated PCBs for my N64HH V2 design, send me a dm if interested in purchasing a batch (1 of each board, so 3 total). I would charge $20 for 1 batch,
All are sold!
That looks sick! This is the board I used, had to use a Dremel to cut a little bit off the front of the pcb to make the usb c protrude enough.
https://a.aliexpress.com/_mLv3ZSk
That looks very clean, but V2 does have different screw posts at the top part of the front, so your print won’t work with the V2 back. V2 is out on the cutting edge section! It is the final design, as far as I can see.