I'm certainly intrigued by this project. I can't wait to see it when it's done. Hopefully everything goes smoothly for you. Best of luck in your endeavors!
I am planning to make a Wii portable based off of the Nintendo Switch Lite's design. I'm going to balance aesthetic and functionality. I don't know if docking will be implemented.
Here is my concept drawing (blurry finger included!):
(The one on the left)
I've already found an RVL-CPU-40 on...
Lmfao, I know that some of the critical components are far away from one another. Some of these may not even be possible (rip portable Wii U). I'm not sure, but would relocation of components work somehow and would it get easier in the future using some custom PCBs? Also, power consumption bro..
I'm not an expert, so take this with a grain of salt. It would be cool if the following consoles could be trimmed:
PS3 Super Slim:
PS3 Slim:
Xbox 360 S or E (E motherboard pictured)
Wii U (Press X to doubt)
Xbox One S (Distant Future)
Xbox One X (Not Sure)
PlayStation or PSone
OG...
I have a Hori Split Pad Pro for the Nintendo Switch and I was wondering if I could mount the joycon motherboard and battery into it and route all the buttons to each other with solder. Is it possible to do that while keeping the turbo and assign features?
With all the information we've been provided, is it possible to make a system on a chip Wii with original hardware, battery saving and custom boot capabilities?