I see you are trying to make a Wii laptop! Very good.
Might I suggest keeping the ports on the board intact and placing them on the side of your laptop casing to gain access to them for multiplayer capabilities? You could even cut the trace for data on the player 1 port and solder a switch to...
Hi all! New to portablazing, avid electronics enthusiast.
I am a yellow transparent roll of tape, with googly eye and tape cape.
BUT
I'm also a helpful memer of mod-ciety!
thank :)
Hello! It looks like you are stuck on resistance for TI regulators.
I believe a 1.8k will work just fine.
Here is the diagram for calculating resistance needed.
As you can see, 1.8k is lower than 1.89k, thus making this ideal for testing!
Good luck. :)