Recent content by honigbrai

No

Looks good, but to be safe I would always recommend trimming a little bit outside the line. Also make sure to tape gpu CPU and ram

You might need to sand more at the top edge of the board

420

I would look out for a 4 layer Wii: https://bitbuilt.net/forums/index.php?threads/revision-identification-guide.863/ .Also when you are trimming I would recommend to tape over the chips, so no dust gets under the CPU, GPU and RAM.

KVM Vga switches should work, but they are very big

Not the same cells, but the brand is the same https://budgetlightforum.com/node/56542?page=1

Please do not buy those batteries, they are used and rewrapped samsung cells

I would remove the Gamecube Memory Slots before trimming

ngb: nostalgia gaming box

I just took a little look at the differences in the i2c registers, there are some changes, but nothing that's too big. Reg01 and Reg3 were changed much, the other changes are minor.(e.g. Reg0C the NTC_FAULT got more sates) I would recommend to definitely use the BQ25898D over the BQ25898...

Yes, the componets should work. But you would need to replace the pic with an other model or battery gauge(I don't know if the BQ needs i2c to work)

You would need to redesign parts of the pcb to work with the ISL8014AIRZ-T7A

This is one of the best 2s cmbs: https://www.ebay.com/itm/Intelligent...2S-Packs-18650-lithium-Satellite/311721987212 It has all protections and it has a charger build into it, this means you can charge it with 9-15V

Yes 100% possible. Try to learn Kicad and Fusion