Hi,
I have been doing some research into the LCD's used in smart phones and am wondering if anyone has a better understanding of the technology then I do.
Basically my question stands:
I have a working android phone:
https://www.gsmarena.com/huawei_p9-7972.php
The screen is damaged and the...
Won't boot at all, no signal. Just tested it then same results this is the current wiring. I am using 12v through the red board so disregard the fact there are only two batteries
Hi guys, i am submitting my wii portable for a school project in 2 days and my wii has stopped working. I had my wii omgwtf trim working but had to make it smaller again and sanded it and it is no longer working, if I want to test whether there are shorts between voltage lines what are typical...
Hi guys,
I have files designed on altium in the following formats,
.cam
.PrjPcb
.Schdoc,
.Pcbdoc
Have been unsuccessful in trying to get them into a format which oshpark accepts (kiKad, EagleCAD or zipped gerber) , wondering if anyone could help.
Thanks :)
okay great advice thanks! I will see if i can find a switch which has larger solder points but the same function, as for the usb C i am using this so soldering at this stage doesn't look to be an issue ...
Hi all,
I have bought a video switch to allow for video out via YPbPr to a wii2hdmi converter. I am also using YPbPr to connect to my Eyoyo screen, just wondering if anyone could help me understand the wiring diagram ( attached below link is...
Hi i am having issues with my trimmed wii.
Freezes and glitches at times on the portabilize mii splash screen.
Freezes once portabilize mii has started, during the blue background stage.
Fails to start sometimes, usually the first time powering it on after a while it wont start, then by the...
Anyone know how to fix this error?
Also it freezes every now and then and the screen flickers at times . what can be done to get the trim working 100%.,
okay testing resistance for the following voltage points:
1v to GND: 154 ohms
1.15v to GND: 60 ohms
3.3v to GND: continuisly changing doesnt settle on a value.
5v to GND: continuisly changing doesnt settle on a value.
Also ran through the u10 test guide and seems all okay.
Removed the hot glue...
There is a short between the 1.15v line and GND. Also seems there is a short between the pin and the shell on my AV cable for some reason. Could these be the issues ?
Thanks