Recent content by E64

PM'd!

I see some spots on the right side and bottom side that seems like there's no connections to the pads do a touch up with your soldering iron with a good tip and use some flux Touch up on all the sides just to make sure they're connected

Did you wire it up right?

I see one of the pins on the front row and back as well has no connection to it maybe that's it That's the only thing I can see

Check your resistors/capacitor for short one of them might have went out

Did you test it after you trimmed it And the traces that was cut off does it go to anything on the other side of the board?

Im looking for someone if it's even possible to 3D print this parts it's for a grinder i've looked online and can't even find the right one that matches it and i need about 30pc ill ship off the one i have to whoever can do it so they'll have a good view of what they're working with i hope...

https://wololo.net/2021/12/07/madlad-cuts-motherboard-in-half-to-create-portable-sega-saturn-and-it-works/ Look at what i found today Anybody else goes to this site?

Its beautiful! i need to start getting into portablizing

I have 2 of the same ones on the left and 5 of the same ones on the right

I have about 4 or 5 of them I'll check it out when I get home

Nice and how can one get video input? Is it possible to get composite or will we have to use a ultra vga for that

Really i haven't seen anyone do it on a later revs I know about the earlier revs

You'll need a different revision of the n64 board if you want to trim it that small