- Joined
- May 11, 2020
- Messages
- 53
- Likes
- 12
Hi, Im still working on my GBoy kit, and so far Ive gotten to the point where Im able to boot the trimmed board (yay!)
however I have a couple questions before I continue.
A) is the included start button supposed to have a membrane behind it? the button doesnt feel like you are pressing anything. was there supposed to be one in the kit or am i supposed to cut up a DSL start/select membrane or is this just how it is?
B) The console returns the no SD card error message even though I believe I have it wired properly. in the manual it shows two D+ and D- points on the wii board. am I supposed to run the D+ and D- from the USB C board to BOTH of the indicated pads, or is this just telling me I could do either one? I soldered to just one since thats what it looked like they were doing in the picture but I cant tell for sure.
Thanks
however I have a couple questions before I continue.
A) is the included start button supposed to have a membrane behind it? the button doesnt feel like you are pressing anything. was there supposed to be one in the kit or am i supposed to cut up a DSL start/select membrane or is this just how it is?
B) The console returns the no SD card error message even though I believe I have it wired properly. in the manual it shows two D+ and D- points on the wii board. am I supposed to run the D+ and D- from the USB C board to BOTH of the indicated pads, or is this just telling me I could do either one? I soldered to just one since thats what it looked like they were doing in the picture but I cant tell for sure.
Thanks