Kaos03
.
- Joined
- Feb 1, 2020
- Messages
- 54
- Likes
- 10
After months of questions research and ordering parts I’m finally starting on my Wii portable the C-wii. It’s just a G-Wii rev 2 but my name starts with a C so I changed the name a bit. I printed the case a few months ago but over time I started to not like the print I dremeled the y button hole to much and so I covered it with duct tape and painted it, and I drilled some of the screw holes too wide and the screws didn’t screw in. But now all of the problems are fixed with the new print. I’ve already put in the d-pad, c stick, shoulder buttons, screen, screen controls, usb-c, pms boards, and the cooling kit some parts block others so I’m waiting to put those in and I’m also waiting for more parts like the Wii, led, and wires. Sorry for the long post. P.S the last 4 pictures are the original case.
Update: I got my wire and I’m going to add a picture of it now I’m just waiting to get the Wii and the led. And I don’t want to start until I get everything. Side note will that be enough wire for the entire thing
Update: I got my wire and I’m going to add a picture of it now I’m just waiting to get the Wii and the led. And I don’t want to start until I get everything. Side note will that be enough wire for the entire thing
Attachments
-
3.1 MB Views: 353
-
2.3 MB Views: 364
-
2.8 MB Views: 330
-
2.4 MB Views: 326
-
3.3 MB Views: 357
-
2.9 MB Views: 348
-
2.9 MB Views: 354
-
2.8 MB Views: 348
-
2.7 MB Views: 316
Last edited: